![]() The multiple hole pattern on the Adapter Arms make it easy to adjust to fit your unique television.Īttach the Adapter arms to the mount as shown.Īfter securing the Adapter arms to the mount, The arms will be attached to the TV using the appropriate screws, washers, and lockwashers as described in Steps 6 and 7. It is recommended to measure the distance between the mounting holes on the back of your TV prior to attaching the Adapter Arms. If you need to use the Adapter Arms, you must use all Adapter Arms in order for the Mount to properly hold your TV. The included adapter arms can be used for Flat Panel monitors with bolt patterns larger than 100 mm x 100 mm. You will not use all of the hardware included. If you feel resistance, remove the bolt immediately and try another size! Next determine the correct length of the required bolt as described in the steps 6 and 7. Thread the bolts carefully into your Flat Panel by hand to determine which provided mount hardware (correct diameter) is appropriate for installation. Select the bolts which most resemble the holes in the back of your Flat Panel. Selecting the Appropriate Hardware for your Flat Panel.You will need 2 screws and anchors for the Small mounts and 4 screws and anchors for the Medium mount. Please be sure to use all wall screws and anchors that are included in the package. Insert the anchors into the holes and set them flush to the wall by tapping them in with a hammer. Drill into the wall at least as deep as the screw is long (2.5 inches). Drill holes for the concrete anchors using an electric drill with a masonry bit (15/32 inches or 12 mm). ![]() Mark the two or four holes you will be using for concrete anchors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |